Image Instructions
In the guide below you can find step-by-step image instructions on how to use the RYLOOBABY SLING.
Step 1
Unfold the wrap, find the logo in the middle of the wrap and put it on your belly. Wind the wrap around your waist.
Step 2
Cross the two pieces behind your back. Bring each side up and over your shoulders to the front while keeping the fabric stretched.
Step 3
Take both pieces in one hand and tuck them under the section with the label on it while keeping the tension. Pull down and cross the pieces to form an X.
Step 4
Cross the wrap behind your back and if there is enough fabric bring it back to the front. (Plus size can tie at the back) You can tie a double knot behind your back, in the front or on your hip.
HOW TO PUT YOUR BABY IN THE SLING
STEP 1
Holding your baby securely, carefully pass his or her leg under the shoulder piece that is closest to your body.
STEP 2
Spread the fabric wide over your baby's entire bottom, back and shoulder (knee to knee). The wider you spread it the more comfortable your baby will be.
Step 3
Tuck your baby under the second shoulder piece and spread out the fabric again. The fabric should be spread out to the back of your baby's knees on both sides.
Step 4
Pull the front panel over your baby's bottom and up to the back of their neck. For newborns, all 3 layers should meet behind the neck.
Rearrange the fabric. Make it comfortable for you and your baby. It should not be too tight.
HOW TO GET BABY OUT WITHOUT UNWRAPPING
✓ Pull the logo parts down under the baby's bottom.
✓ Open the fabric supporting the baby as you do this. Newborns will need head support.
✓ Lift your baby straight up and out of the wrap.
✓ Trying your wrap can take a few tries, but once you find your groove, there is no turning back!